From: John Sweeney (john.sweeney_at_informark.com.au)
Date: Mon Aug 26 2002 - 06:11:22 CEST
I have been trying to get the dhcprelay facility working. It is the one that is
advertised on www.strongsec.com freeswan site. I now have it working
(mostly) except that I need to tell my vpn gw, the freeswan box to
advertise that it is the box responsible for the new virtual ip on the
network. The network is principally W2K, with a dhcp server of that stripe.
I am using SSH Sentinel 1.3.2 for the road warrior machine. I still seem to
need both conn sections as defined in the DHCP relay HOWTO. Once I
make the connection, I need to ensure that the freeswan box, which is
acting as the default gw for the network publishes itself on the ARP with
the following command:
arp -vs 10.200.101.56 xx:xx:xx:xx:xx pub
where the x's refer to the hardware address of the freeswan box's eth0.
Once I do that, everything else seems to be fine. It would be nice to have
non-manual solution to this little problem. Anyone have any suggestions?
John
********************************************************************
Informark Pty Ltd
www.informark.com.au
phone: +61 (0)2 6230 0555
fax: +61 (0)2 6230 0333
This email message and any accompanying attachments may contain
information that is confidential and is subject to legal privilege.
If you are not the intended recipient, do not read, use, disseminate,
distribute or copy this message or attachments. If you have
received this message in error, please notify the sender immediately
and delete this message. Before opening any attachments, please check
them for viruses and defects. Informark and/or its employees shall
not be liable for the incorrect or incomplete transmission of this
e-mail or any attachments, nor be responsible for any delay in receipt.
_______________________________________________
Users mailing list
Users_at_lists.freeswan.org
http://lists.freeswan.org/mailman/listinfo/users
This archive was generated by hypermail 2.1.4 : Mon Aug 26 2002 - 10:19:54 CEST